home *** CD-ROM | disk | FTP | other *** search
- The lamp of scanner is too dark.
- (Restart the scanner and redo
- scanning. If this error happen
- again, please refer to Scanner
- Operational Manual to change
- a new lamp.)
-
-
- The lamp of scanner is off.
- (Restart the scanner and redo
- scanning. If this error happen
- again, please refer to Scanner
- Operational Manual to change
- a new lamp.)
-
-
- The motor or home position sensor
- of the scanner is out of order.
- (Restart the scanner and redo
- scanning. If this error happen
- again, please contact your local
- dealer.)
-
- The lamp of scanner is too light.
- (Restart the scanner and redo
- scanning. If this error happen
- again, please refer to Scanner
- Operational Manual to change
- a new lamp.)
-
- The scanner fails to do calibration.
- (Restart the scanner and redo
- scanning. If this error happen
- again, please contact your local
- dealer.)
-
- The scanner ROM is out of order.
- (Restart the scanner and redo
- scanning. If this error happen
- again, please contact your local
- dealer.)
-
- The scanner RAM is out of order.
- (Restart the scanner and redo
- scanning. If this error happen
- again, please contact your local
- dealer.)
-
- The scanner CPU is out of order.
- (Restart the scanner and redo
- scanning. If this error happen
- again, please contact your local
- dealer.)
-
-
- The scanner's SCSI controller is
- out of order.
- (Restart the scanner and redo
- scanning. If this error happen
- again, please contact your local
- dealer.)
-
-
- The scanner's 8253 chip is out of
- order.
- (Restart the scanner and redo
- scanning. If this error happen
- again, please contact your local
- dealer.)
-
- Driver fail to communicate with
- scanner.
- (Check cable connection, SCSI ID.
- Restart the scanner and redo sca
- nning. If this error happen again,
- please contact your local dealer.)
-
- The driver has received an unkno
- wn scanner error message.
- (Restart the scanner and redo
- scanning. If this error happen
- again, please contact your local
- dealer.)
-
- The scanner receives illegal set
- tings.
- (Modify scan mode settings, re
- start the scanner and redo scan
- ning. If this error happen again,
- please contact your local dealer.)
-
- The driver fails to request an error
- code from scanner.
- (Restart the scanner and redo
- scanning. If this error happen
- again, please contact your local
- dealer.)
-
- The scanner can't find the filter of
- the scanner.
- (Restart the scanner and redo
- scanning. If this error happen
- again, please contact your local
- dealer.)
-
- Unknown scanner hardware error.
- (Restart the scanner and redo
- scanning. If this error happen
- again, please contact your local
- dealer.)
-
-